Frimec CO2/h Heat Recovery Probe

Frimec CO2/h Heat Recovery Probe

This module allows for real-time air quality monitoring in specific areas. It measures humidity, temperature, CO₂, PM2.5, and VOCs. It can be used with energy recovery systems to improve indoor air quality. The HRV (Heat Recovery Ventilator) will operate based on the module's data and required parameters. This product requires no installation and can be placed in offices, homes, and other high-traffic areas to ensure optimal air quality.

1-to-1 Connection (1 wired remote control vs. 1 wireless IAQ module)
1. Power on the HRV and start it using the wired remote control model 13130-zig. Ensure it is functioning correctly.
2. Connect the IAQ module to the mains power supply via the 220 VAC/5 VDC interface. The module's indicator light will flash.
3. The IAQ module and the wired remote control connect automatically, and the module's indicator light stops flashing. When first connecting the IAQ module, it is recommended to perform a short-range test to verify its operation before installing it in its final location.
One-to-many connection (1 wired remote control for multiple IAQ modules, up to 15 modules).
The procedure is the same as for a one-to-one connection, but before connecting the power to the IAQ modules, you must configure their microswitches.

A. Unscrew the four screws located on the underside of the IAQ module.
B. Open the cover to configure the module number using the DIP microswitch (select the number shown on the wired remote control; the default value is 1, as shown below).
Two IAQ modules connected to the same wired remote control in the same zone cannot be configured with the same number; this could cause communication problems.

Displaying Room Air Quality
A. With the HRV off, press and hold the MODE button for 5 seconds to access the settings interface.
B. Press the SET button to select the settings. The IAQ module number (parameter 27) can be changed.
C. In the parameter 27 settings interface, press the MODE button. The serial number will flash, indicating that you are in settings mode. Use the Up and Down buttons to select the IAQ module to monitor, then press the SET button to confirm. Enter the number of the selected IAQ module.
D. The data collected by this module will then be displayed by default on the wired controller (and also in the app).

Name
Wireless Air Quality Monitoring Module (IAQ Module)
Model: AS-AQ010Z
Power Supply: Adapter: 220 VAC~50 Hz / 5 VDC
Module: 5 VDC
Connection Type: USB-C
Operating Temperature: -15°C to 50°C
Operating Humidity: 20% to 90% RH (non-condensing)